The hot air preheating u- shaped heater, long service life, reduce maintenance downtime. Internal reinforcement insulation plus optional external protection device can effectively reduce the heat loss , energy saving up to 20% compare with traditional equipment. Low equipment surface temperature can optimize the working environment.
¡ñ External Spray Fluxer , safety, cost, space and maintenance problems resolved£º
External Spray Fluxer combined the advantages of inner and independent spray, the spray and machine can be integrated control, no increase in cost; Spray fluxer away from preheating zone, and ensure safety and clean; Transportation of new type titanium alloy heavy duty claw, sectional guide rail design, stainless steel strip supported in guide rail, long life; The solder pot adopts special materials, Anti corrosion coating on surface; Adopt imported precision nozzle, atomization uniformity, high efficient.
¡ñ The large promotion of solder pot£º
Nozzle quick released, reduce maintenance time, 2 hours to a few minutes; Grid type of mesh, reduce the mesh block by solder dross monthly maintenance extended to six months; Optional solder supply device, reduce the influence of wave height caused by the change of tin solder level;
Model No. | 350 Series |
GXS-350-M | |
Dimension£¨L×W×H£©mm | 3885*1655*1710 |
Spray Fluver Dimension £¨L*W*H)mm | 1300*1350*1595mm |
Power Supply | AC 380V 3Φ5W 50/60Hz £¨Option £ºAC 220V3P 50/60Hz£© |
Initial/Operating Power | 80KW/8KW |
Starting power | 37KW |
Air Source | 0.5-0.8Mpa |
Control System | PC+PLC |
Flux Flow | 10〜100ml/min |
Exhaust Tube Diameter | Φ 200 mm |
Exhaust Mode. | Upward |
Preheat Mode | IR / Hot Air |
Preheat Zone Number | 3 zones/1800mm |
Preheat Temp. Range | Room Temp.〜230¡æ |
Temp. Control Mode | PID+SSR |
Solder Pot Type | Mechanical Pump |
Pot Capacity | Approx. 480kg |
Max. Soldering Temp. | MAX £º300 ¡æ |
Wave Driving Power | 1/4 HP X2 |
Wave Height Control | Inverter |
Heat Up Time | Approx .150min £¨Setting£º250¡æ£© |
PCB Conveying Speed | 300〜1800mm/min |
The Width Of PCB | 50-350mm |
Component Height | Top£º120mm Bottom£º 25mm |
Transport Height | 750±20mm (Entrance) |
Conveyor Angle | 4〜7° Adjustable |
Speed Control Mode | Inverter |
Cooling Method | Forced Air Cooling £¨Opiton£ºchiller£© |
N2 System | SMART-350-M-N |
Nitrogen Consumption | 15m³/h Below 1000ppm |
Pressure Nitrogen Source | 0.5〜0.8Mpa |
Oxygen Nitrogen Source | ≤10PPM |
Oxygen Analyzer | Option |