AKP Series of Wave Soldering Machine
AKP Series of Wave Soldering Machine Wave Soldering Machine JT Machinery Malaysia, Penang, Johor Bahru (JB), Thailand, Philippines, Vietnam Supplier, Distributor, Supply, Supplies | OS Electronics Sdn Bhd
¡ñ New solution of preheating:

The hot air preheating u- shaped heater has a long service life, and reduces maintenance downtime. Internal reinforcement insulation plus an optional external protection device can effectively reduce the heat loss, energy-saving up to 20% compared with traditional equipment. Lower body temperature with better work enviroment.

¡ñ External Spray Fluxer, safety, cost, space, and maintenance problems resolved£º

External and independent spray control system, ensure the safety and clean, easy to operate and maintenance; Transportation of new type titanium alloy heavy-duty claw, sectional guide rail design, stainless steel strip supported in guide rail, long life; The solder pot adopts special materials, Anti corrosion coating on surface; Adopt imported precision nozzle, atomization uniformity, high efficient.

¡ñ The large promotion of solder pot£º

Nozzle quick released, reduce maintenance time, 2 hours to a few minutes; Grid type of mesh, reduce the mesh block by solder dross monthly maintenance extended to six months; Optional auto solder supplying device, reduce the influence of wave height caused by a drop of solder level;



 

MODEL No. 350 Series
AKP-350-M
Wave Soldering Outside Dimension(L*W*H) 3945×1582×1735mm
External Spray Fluxer Outside Dimension(L*W*H) 1300×1350×1595mm
Power Supply 3P5W 380V AC 50/60Hz
Option:3P5W 220V AC 50/60Hz
Operating Power ≤9KW
Power For Warm Up 30KW
Air 0.5Mpa-0.8Mpa Air
Control Mode PC£«PLC
Spray Flow 10~100ml/min
Exhaust Pipe Diameter Φ200mm
Air Outlet Mode Up-down Convection
Preheat Mode Hot Air Preheating / Infrared Preheating
Preheat Zones Number 3 Zones 
Preheat Temperature Room Temperature¡«230¡æ
Preheating Temperature Control Mode PID+SSR
Working Mode of Tin Furnace Mechanical Pump
Tin Furnace Capacity Lead-free£º About 480KG
MAX Temp of Tin Furnace MAX: 300¡æ
Wave Driving Power 1/4 HP×2 
Warming Up Time About 140 min£¨Setting Temperature£º265¡æ£©
PCB Transmission Speed 300~1800mm/min
Width Range of PCB 50-350mm
PCB Board Component Height Top 120mm, Bottom 25mm
PCB Inlet Transport Height 750±20mm
Transport Guide Rail Inclination Factory£º5.5°±0.2°£¨4°— 7°Adjustable £©
Cooling Mode Forced Air Cooling
Nitrogen Consumption 15m³/h below 2000ppmÒÔÏÂ
Pressure Nitrogen Source 0.5¡«0.8MPa
Oxygen Nitrogen Source ≤10PPM
Oxygen Analyzer option

Please leave your enquiry here, we will reply as soon as possible.


*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version